Duschinsky Rotation and decomposition recorganization energy

usmanqureshi · 发表于 Post on 2021-10-28 09:38:47

Dear Dr. Tian Lu !

According to your answer on my querry, I did not the graph which you have mentioned in your article http://sobereva.com/330. Also my question is why you select the only last values as its first "1am=" values are nearly and almost zero?
What was your criteria for this data selection?
Why the unit on both x-axis and y-axis you mentioned are cm-1 ?

sobereva · 发表于 Post on 2021-10-28 13:38:46

There is no criterion. Simply use the following two columns as X-axis and Y-axis to plot bar map. If the "Lam=" of a frequency is very close to zero, then it will not be visible in the map.

usmanqureshi · 发表于 Post on 2021-10-28 14:13:48

Then if I want to calculate the ISC or RISC rates between the S1 and T1 states then for Duschinsky calculations, I will use the S1 and T1 frequency files or same as S0 ->S1?
Actually my question is that duschinsky matrix are only calculated between S0 and S1 state to find the decomposition reorganization energy and huang rays factor or it depends upon the state of interest which we required for ISC and RISC rate calculations?

		自动登录 Automatic login	找回密码 Forget password
密码 Password			注册 Register

[辅助/分析程序] Duschinsky Rotation and decomposition recorganization energy

浏览过的版块